STANDARD FINISHING OF FLATS
1. Primers for flooring
Cementitious screeds erased mechanically stacked with Styrofoam insulation. The level of cementitious screeds in all areas at the same height. Primers prepared for panels or tiles
2. Supporting walls
24cm thickness of silicate blocks and aerated concrete
3. The interior plaster walls and ceilings
Single-layer, plaster done mechanically category III., Prepared for filling and painting
Storey monolithic reinforced concrete on the garage door and reinforced concrete filigree on the residential floors
PVC innovative hardware, gaping, Tilt-turn (as documented construction) with a veneer exterior wood-colored, double glazed with a coefficient Umax = 1,3W / m2K. Under the windows sill 3cm thick conglomerate.
6. Entrance doors to apartments
Burglar, single, complete with apartment number and visor
With silicate blocks / concrete blocks plastered on both sides
Isolated przeciwwilgociowo, balustrades in the form of steel-and-glass elements, according to the draft
9. Electrical Installation
Approach 3-phase electric kitchen; jack 20-30cm above the floor, switches, about 1.4m above the floor, the installation of an electric bell. Switches and sockets in white, the points of light ended dice. The distribution and quantity according to the project
10. Installation of water and sewage
Installation of hot and cold water run in floors, ducts or chases. Water meter for each premises. Sewage system with PVC pipes run in floors, ducts or chases. It does not include white assembly
11. The gas pipe
Does not occur in premises
12. Install C.O.
Pipelines C.O. carried out in the roof floor of the lower layers connection of radiators. Steel radiators, and panel valves termoregulacyjnymi. Heat consumption meter
13. Installation of television, telephone and Internet
To bring the installation into each dwelling for TV, TEL, INTERNET. Location outlets according to the project
14. Intercom installation
One dwelling intercom connection with the entrance to the stairwell
STANDARD FINISH OF THE BUILDING AND COMMON SPACES (INSIDE)
1. Internal plasters
Gypsum, machine, painted with emulsion paint
The stairwell and boiler room porcelain tiling or equivalent solutions.
The stairwell with a height of 110cm, openwork profiles and painted steel pipes
4. Window frames
PVC windows, double glazed
5. Entrance to the building
Double exterior doors in an aluminum frame, glazed with safety glass with self-closing
6. Hall garage
Access to the garage from the outside through a gate controlled by remote control, inside through elevator and stairwell,
The building has two elevators from the garage to the last floor.
STANDARD FINISH BUILDING EXTERIOR
1. The facade of the building
Structural thin film on a layer of polystyrene 15 cm; with the invoice lamb.
2. External window sills
In the steel sheet coated with flange.
Flat, covered with tar paper on a layer of polystyrene 15cm, gutters and downspouts.
4. Driving and pedestrian access to the building
Access roads and pedestrian streets lined with concrete on cement-sand posypce
Made of concrete blocks full or openwork.
6. Land development
The area around the building fenced and planted with grass.
Standard of finish
STANDARD FINISHING OF FLATS